Sony D-515 right channel not working correctly.
Hello everybody here!I recently bought a d-515 in "untested" condition. After some capacitors and a little bit of laser adjustment, the unit reads discs perfectly. Now, the only issue that remains is that the right channel is not working propertly (in both line out and headphones, batteries or 9V DC). It can be heard at a lower volume, cracking. If you apply hot air on the main board for 5 seconds, then the channel works fine for the rest of the day. The area is far away from electrolyte and nothing can explain a bad soldering. Since the left channel is always working fine, I suppose that all the digital circuit is ok and the error is somewhere between the DAC and the line out jack. (tell me please if this assumption is wrong). Since the left channel is working always, I don't think this is a power supply problem. What can the error be, can it be a transistor or a resistor? Can the DAC cause this error?
Any help is greatly appreciated!
Thanks a lot! Classic cap issue. Suggestion: replace all SMT caps with original parameters and clean the leaking. Hello! I am so happy to hear that! Capacitors are the next step. I was a bit confused because this happens only on the one channel. Again, thanks a lot for your help! Hello again, I have now replaced all the capacitors, cleaned all the leak. No broken lines under any capacitor. The problem remains the same ( Right channel distorted in both line out and headphones) The weird thing is, that if i warm up the unit just a little, it will play fine for a few hours... I also looked for a cracked solder, but i couldn't find anything. What could it be? can it be the DAC? (The voltages are fine) any ideas???
Thanks a lot for any help!
kostgeor Follow the service manual, check the DAC and pre-amp. Ordinary broken via or trace. :lol
Pages:
[1]